Thingiverse
Ceramic Swallow
12
Downloads
15
Likes
0
Makes
Took over 55 photos of the ceramic swallow, then uploaded it into Autodesk ReMake. Modified and trimmed the mesh, then exported it as an STL. Imported the STL into Netfabb to repair the STL, and also turn the shell into a 3D solid. Then exported the STL again. Then I 3D printed it.
Interestingly, ReMake worked on this in mm, needed to scale 1000% in Netfabb to size as cm. STL attached should be in cm - about 15 x 16 cm.
Interestingly, ReMake worked on this in mm, needed to scale 1000% in Netfabb to size as cm. STL attached should be in cm - about 15 x 16 cm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!