CGS piston socket

This tool is for tightening the rear ring on the booster of a CGS MOD9 silencer. This also fits the Kraken silencers and the Nautilus 45. Designed to fit a 1/2" square drive. Printed in PLA+ with 2 walls and 90% infill, I used my first model with an impact wrench (on low setting) and saw no damage to the socket teeth or the 1/2" drive hole. The tool did not break after 5-6 uses, and that's the limit of my testing.

My temps and Z-offset give me a very slight elephant's foot, so I added bevels to the inside and outside of the drive side rather than fix my print settings. I also changed the outside shape from a 35mm square to 36mm hex. The end result was a tight fit on the 1/2" impact wrench and a little wiggle room on the booster ring.