Thingiverse
Cheap FOCER 2 single case
von helno
3
Downloads
2
Likes
0
Makes
Case to hold a single Cheap Focer 2 board and heatsink.
The correct spacing for the heatsink is achieved and there is enough room under the board to hold onto your receiver and other small acessories.
There are two versions one with holes for the caps and another without. If you want to hid the caps just solder them on with the caps resting under the board. Secure the caps with some silicone.
Attaches using 6 #4 flat head screws.
The correct spacing for the heatsink is achieved and there is enough room under the board to hold onto your receiver and other small acessories.
There are two versions one with holes for the caps and another without. If you want to hid the caps just solder them on with the caps resting under the board. Secure the caps with some silicone.
Attaches using 6 #4 flat head screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
