Thingiverse
Cherokee-E Model Rocket
door Aslansmonkey
55
Downloads
22
Likes
0
Makes
You'll need a BT-55 body tube, shock cord, 18" parachute and screw eye bolt to complete this rocket. You will NOT need a motor tube as it's part of the 3D design.
Print the fins with support, of course.
The nose cone base is designed to use an eye bolt. Epoxy the nut to the INSIDE of this piece and run the eye bolt through the bottom. That way you can add washers for weight as needed. And you WILL need them, especially running an E motor. I had to add like 5 fender washers to get it to swing stable.
The 24mm adapter print as is (rotate it 90 degrees, if necessary, to print it flat). This part is UNMODIFIED from ellipiticaloptician's original design.
The fin can is sized for an E motor. You can use an adapter from here (https://www.thingiverse.com/thing:3080175) to use a D motor, should you choose, or that adapter and one of the parts from here (https://www.thingiverse.com/thing:3071923) to use Aerotech motors (which go up to F in this size). Before you ask, no, I do
Print the fins with support, of course.
The nose cone base is designed to use an eye bolt. Epoxy the nut to the INSIDE of this piece and run the eye bolt through the bottom. That way you can add washers for weight as needed. And you WILL need them, especially running an E motor. I had to add like 5 fender washers to get it to swing stable.
The 24mm adapter print as is (rotate it 90 degrees, if necessary, to print it flat). This part is UNMODIFIED from ellipiticaloptician's original design.
The fin can is sized for an E motor. You can use an adapter from here (https://www.thingiverse.com/thing:3080175) to use a D motor, should you choose, or that adapter and one of the parts from here (https://www.thingiverse.com/thing:3071923) to use Aerotech motors (which go up to F in this size). Before you ask, no, I do
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!