Thingiverse
Chisel and hand plane blade sharpening jig
door _Krytz
4
Downloads
6
Likes
0
Makes
A jig to set the 25 degree bevel angle
The bottom of the bearing support should be 2mm off the ground and be parallel with it
This sets the whole jig angle to 25 degrees
Assembled with
2x M5 threaded rod
2x hex / wing nuts
2x M8 bolts
2x 608 bearings
I recommend gluing in the hex nuts at the end of the threaded rod
The bottom of the bearing support should be 2mm off the ground and be parallel with it
This sets the whole jig angle to 25 degrees
Assembled with
2x M5 threaded rod
2x hex / wing nuts
2x M8 bolts
2x 608 bearings
I recommend gluing in the hex nuts at the end of the threaded rod
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
