Chopper light bracket

This bracket is meant to be milled from aluminum, it's a prototype I made to relocate my headlight from my springer front to underneath the tank. two holes for bolting on the frame. Works good, might actually leave it as is and not mill it.... Red because that was on the printer, PETG because it's too hot to have window open for ABS.... Less than an hour with my settings.

Couple little changes in V2.0, extrusions for "tooth" lock washers inside to crab onto the light base and bigger washers outsid.... Printed final version with 50% infill.

Added a No Frame Groove version, and somebody asked for dimensions of the base plate, measurements are in metric.