Christams tree

Christmas tree now for all printers. included are the A1,A1mini, P1s and X1C profiles.for p1s and x1c, please ensure the over 100% wall (not bridge) is between 10-20also make sure the auxiliary fan is off and the toolhead fan is at 100% The A1 does a good job without changing any settings however you can still play around with over 100% wall (not bridge) settingthis setting is found in "speed.no fan adjustments are necessary Do not resize as it wont print correctly.must be printed at 0.2 layer height as the tree branches are the exact width of a single pass back and forth. and 0.28mm in height which prints at 1 layer. infill set at 15%. but a great little table decoration and just 18 grams of filament. looks great in a dual or tri colour filament. aslo be careful if you print more than one and get them near each other, they are like velcro and hook on to each other. many more models available and with commercial license on patreon and thangs Boost Meif you liked this model please c