Thingiverse
Cigar Case
door Daalbock
113
Downloads
79
Likes
1
Makes
Made a simple Cigar-Case which holds four 130mm long cigars with a diameter of 18mm.
Made a little slot in the lower part for attaching a 1cm rubber band which holds the top on.
Gap between top and bottom part should be around 0.1mm for a relative tight and wigglefree fit.
Size can be adjusted within the slicer to fit different sizes of cigars.
Printed with a 0.4mm Nozzle on my Anycubic i3 Mega with Sunlu PLA+ and a Layer-Height of 2mm.
Have fun with it!
Made a little slot in the lower part for attaching a 1cm rubber band which holds the top on.
Gap between top and bottom part should be around 0.1mm for a relative tight and wigglefree fit.
Size can be adjusted within the slicer to fit different sizes of cigars.
Printed with a 0.4mm Nozzle on my Anycubic i3 Mega with Sunlu PLA+ and a Layer-Height of 2mm.
Have fun with it!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!