Thingiverse
Circle Twisted Vase
von thetechbros
35
Downloads
42
Likes
0
Makes
This is a 120 degree Tri- Circular twisted vase 4 inches tall and approximately 4.25 inches in diameter with an .035 inch wall thickness which works well with a .4 mm nozzle
material: black ABS 1.75mm
Printed on a XYZ Da Vinci 2.0 with 30% infill even though their is no space in the wall and a 200 micron resolution layer height. and no support material.
This part was saved at a very high STL resolution to get the smoothest lines available, and this vase has no hard lines or corners so it turns out really well on cheap printers.
This vase is good for a small plant,or a pen / pencil holder, or anything your heart can desire.
Please Share pictures if you printed this part out.
material: black ABS 1.75mm
Printed on a XYZ Da Vinci 2.0 with 30% infill even though their is no space in the wall and a 200 micron resolution layer height. and no support material.
This part was saved at a very high STL resolution to get the smoothest lines available, and this vase has no hard lines or corners so it turns out really well on cheap printers.
This vase is good for a small plant,or a pen / pencil holder, or anything your heart can desire.
Please Share pictures if you printed this part out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
