Thingiverse
Circular LED Casing
door xordac
1
Downloads
1
Likes
0
Makes
Adding some lightning to my cheap 3D printer, I had a 12v circular LED I will use and I needed a casing/mount for it. In this first part I made the casing. Havent decided on the mount type yet. The case is made so LED cables and contacts slide in and keep LED in place inside the mount.
v.02 Increased Casing Diameter by 2mm Since it was too tight to mount the LED
v.03 Added pinhole after first print because it is extremely hard to get LED back out. Ensure you solder wires etc before snapping it in.
v.02 Increased Casing Diameter by 2mm Since it was too tight to mount the LED
v.03 Added pinhole after first print because it is extremely hard to get LED back out. Ensure you solder wires etc before snapping it in.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!