Thingiverse
Engineering
Model downloaden
Classic Mousetrap
1
Downloads
3
Likes
0
Makes
This was based on a mousetrap I found at my grandpa's house. I hope everyone enjoys this model by Logan's Workshop.
How to assemble: Step 1: Glue Half 1 to Half 2 with the rectangular part on Half 1 in the
slot on Half 2.
Step 2: Run a string through Rod and Beam, tying them together with
about an inch in between them.
Step 3: Take Beam and put the end without a hole in it in the hole on
Door
Step 4: Put the edge with the flat side on Rod on the edge of the main
trap, so that it holds the door up using Beam. Coat
Rod in peanut butter if you are going to set i because mice love
peanut better. You may need to sand Beam to fit.
How to assemble: Step 1: Glue Half 1 to Half 2 with the rectangular part on Half 1 in the
slot on Half 2.
Step 2: Run a string through Rod and Beam, tying them together with
about an inch in between them.
Step 3: Take Beam and put the end without a hole in it in the hole on
Door
Step 4: Put the edge with the flat side on Rod on the edge of the main
trap, so that it holds the door up using Beam. Coat
Rod in peanut butter if you are going to set i because mice love
peanut better. You may need to sand Beam to fit.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
