Thingiverse
CleverCoffee PCB Case
von FtheT
4
Downloads
4
Likes
0
Makes
CleverCoffee PCB Box with screwable Lid for Rancilio Silvia PID upgrade.
Designed for Minimal Rev 1.5. PCB.
Intended mounting position is the rear bottom underside using the two open holes below the vibration pump. Thus, it is mounted reversible.
Since no significant temperature source is around there, PLA is sufficient. Tree support touching built plate recommended.
Required:
2x countersunk screw M5x10 or M5x12
2x M5 Flat Washer
2x M5 Self Locking Nut
4x countersunk screw M4x8 or M4x10
4x cylinderhead screw M3x8
Thread Cutter M3 for PCB mounting holes
Thread Cutter M4 for Lid mounting holes
Designed for Minimal Rev 1.5. PCB.
Intended mounting position is the rear bottom underside using the two open holes below the vibration pump. Thus, it is mounted reversible.
Since no significant temperature source is around there, PLA is sufficient. Tree support touching built plate recommended.
Required:
2x countersunk screw M5x10 or M5x12
2x M5 Flat Washer
2x M5 Self Locking Nut
4x countersunk screw M4x8 or M4x10
4x cylinderhead screw M3x8
Thread Cutter M3 for PCB mounting holes
Thread Cutter M4 for Lid mounting holes
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
