Clip-on Screen Tray | Bambu A1

by jhon · 3D Printer Accessories

18 Downloads

23 Likes

10 Makes

This handy little screen tray is <80 grams, yet is quite useful for holding a USB stick, micro SD cards, and the basic bed scraper! It takes just under 3 hours to print, making it a handy tool to have to store some frequently used items, without needing a box/drawer or larger storage container. To assemble, simply push the clip and tray firmly together, aligning the two snap joints and the square peg. You should hear a satisfying “SNAP” when doing so, and the two pieces should be solidly attached. Note that there is some extra clearance in the clip for fitting around the screen. This is intentional to avoid any potential damage to the screen due to differing print tolerances. If the clip is loose, apply short strips of masking tape on the edge of the screen until the part stays firmly in place, as shown below: Enjoy your shelf!