Thingiverse
ClipTech compatible Clip/Latch
von Ironfacebuster
24
Downloads
52
Likes
0
Makes
## I'm still working on getting everything fitting properly
I don't recommend printing this as it is now, there are a bunch of small things that need to be fixed (but if you're willing to deal with them, go right ahead!)
Right now, it'll latch pretty well into [my hub](https://www.thingiverse.com/thing:6378827), but it has some trouble with a ToughBuilt hub
-----
Due to the geometry of the actual latch, I tried printing flat (latch side down) so the spring doesn't just break the first time you try to use it, and to save time. There's probably a better way to do this though :)
Of course, supports are recommended
I don't recommend printing this as it is now, there are a bunch of small things that need to be fixed (but if you're willing to deal with them, go right ahead!)
Right now, it'll latch pretty well into [my hub](https://www.thingiverse.com/thing:6378827), but it has some trouble with a ToughBuilt hub
-----
Due to the geometry of the actual latch, I tried printing flat (latch side down) so the spring doesn't just break the first time you try to use it, and to save time. There's probably a better way to do this though :)
Of course, supports are recommended
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
