Thingiverse
Clothes Hook
von andersborg
4
Downloads
5
Likes
0
Makes
I needed more clothes hooks so I made clothes hooks, similar to the metal hooks I already had. They are designed for 25 mm (1") round shelf ribs.
It's a bit hard to print but the provided example shows what I found to be the best angle (45 degrees) to retain smoothness on the sides that are in contact with clothes and the shelf. I added the left supports manually to secure it wouldn't keel over.
The Sunly PLA+ I used is very strong, which was great for this application.
It's a bit hard to print but the provided example shows what I found to be the best angle (45 degrees) to retain smoothness on the sides that are in contact with clothes and the shelf. I added the left supports manually to secure it wouldn't keel over.
The Sunly PLA+ I used is very strong, which was great for this application.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
