Slicer Discord
CO2 Rocket – Modelo 3D imprimible de Thingiverse Thingiverse

CO2 Rocket

por 24mhaggag
5 Descargas
8 Likes
0 Makes
Ver Modelo
This is a rocket that uses a 12 gram CO2 canister meant for BB guns to propel itself about 50 feet in the air. We used this PVC pipe with a nail in the bottom to puncture the seal at the bottom of the canister. The pressure released from the compressed canister launched out the rocket. The launcher is easy to build. We just used a piece of wood with a nail in it. It is important that the nail is centered and sharp. To launch the rocket, put a co2 canister in the rocket and put the nose cone on. Put the rocket in the tube and hold with your thumb. Than slam down on the rocket as hard as you can. The harder you do it, the higher it will go. Our testing estimates that this rocket went about 50 feet. Sadly, we could not put a photo of the printed rocket because in our second test, it fell on the third floor of a currently renovating building. Just goes to show how high it goes.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Wood PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección