Cobblebot Endstop

This is an endstop that I quickly created for my cobblebot. I went through a few revisions before getting a design that worked.

As you can see I have mounted it for the X and Y in a cobblebot basic endstop mount. The hollow in the middle of one side is to allow for the pins that are soldered on the bottom of the board.

You would probably need to mirror it for the Z endstop, but as I am using auto bed leveling I never tried.

Printed on a K8200,
Sliced by Simplify3D,
60% infill (Hex)
.2 layer height
PLA.

M5 bolt needed to the 20x20 frame
and 2 M3 bolt/nuts to attach the endstop board.

Its quick and dirty but works (mounted both ways).