Thingiverse
Coffee Filter Separator
von banjopad
2
Downloads
1
Likes
0
Makes
This is NOT for users of the Kcup coffee makers. Only for users of the old filter type brewers.
I have always had trouble getting one coffee filter to separate from the stack and have not found one that works till now.
Its 1 file , no supports and a easy print.
There is a 3 X 9 mm hole in the top to insert a magnet.
On the bottom place a double side foam tape. I designed this one to look like a lighthouse.
Place it on a metal spot on the coffee maker held by the magnet.
I have always had trouble getting one coffee filter to separate from the stack and have not found one that works till now.
Its 1 file , no supports and a easy print.
There is a 3 X 9 mm hole in the top to insert a magnet.
On the bottom place a double side foam tape. I designed this one to look like a lighthouse.
Place it on a metal spot on the coffee maker held by the magnet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
