Thingiverse
Coffeebit simple
door FruityPebbles
2
Downloads
4
Likes
0
Makes
An adapter so you can use a drill or cordless screwdriver to run your hand cranked coffee grinder.
This is a remix of the original Coffeebit, changed to better my fit coffee grinder and drill. I removed the cup that fits over the coffee grinder handle attachment; the cup interferes if the handle attachment is flush with the coffee grinder lid. I also shortened the shank and changed it to plain hex throughout the length; this works better with the quick-change bit holder I use on my drill.
I recommend 3 perimeter shells and high infill for strength.
I got better results printing "upside down" - shank down, coffee grinder side facing up - and with a raft.
You may need to fine tune the size. At 100% the shank printed exactly 6.35mm, but was too large to insert into my bit holder. At 98% both the bit holder and the coffee grinder fit well.
This is a remix of the original Coffeebit, changed to better my fit coffee grinder and drill. I removed the cup that fits over the coffee grinder handle attachment; the cup interferes if the handle attachment is flush with the coffee grinder lid. I also shortened the shank and changed it to plain hex throughout the length; this works better with the quick-change bit holder I use on my drill.
I recommend 3 perimeter shells and high infill for strength.
I got better results printing "upside down" - shank down, coffee grinder side facing up - and with a raft.
You may need to fine tune the size. At 100% the shank printed exactly 6.35mm, but was too large to insert into my bit holder. At 98% both the bit holder and the coffee grinder fit well.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
