Thingiverse
Coller Sample
di JPArt
1
Download
1
Likes
0
Makes
Best 3D Printers
I made a coller semple which used to be a test semple but I later adapted it so that I have now become the coller sample. but not everyone likes a triangle so I have now made 10 variations something for everyone. I rarely stayed at the triangle, but that could change later.
Printing the Coller Semples takes about 25 to 30 minutes with a z height of 0.1, which gives a good result.
If you receive a commission, it is also good for the customer to see that you are also a correct 3d prinetr with the coller semple.
Leave a little behind on the site what you think of it.
If you still think my model is not included, you may be able to make a model to your liking.
Good luck
I made a coller semple which used to be a test semple but I later adapted it so that I have now become the coller sample. but not everyone likes a triangle so I have now made 10 variations something for everyone. I rarely stayed at the triangle, but that could change later.
Printing the Coller Semples takes about 25 to 30 minutes with a z height of 0.1, which gives a good result.
If you receive a commission, it is also good for the customer to see that you are also a correct 3d prinetr with the coller semple.
Leave a little behind on the site what you think of it.
If you still think my model is not included, you may be able to make a model to your liking.
Good luck
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!