Colored Grinch Bust

Hello Everyone! I wanted to print off a couple of these for a Grinch Themed Christmas party, but I really wanted to have them colored with the original colors. Since I only have a single AMS, I could not color his pupils black. So I will be doing that during post processing with some acryllic markers. The model has lots of small overhangs, so there is going to be a lot of supports needed. I was able to print successfully with tree supports with minimal problems. I reduced the flushing volumes to .6 of the suggested amount. No problem even when switching off of white to red, or vice versa. Also I used the flush in infill to reduce as much waste as possible. I printed 4 copies per plate, with a 0.4 nozzle at 0.2 layer heights. Each print took 17.5 hours on my P1S. This is my first upload so if I am missing anything, please let me know!