Thingiverse
Comet 67P
von grandaspanna
8
Downloads
6
Likes
0
Makes
This is a 3D model of the comet 67P (67P/Churyumov-Gerasimenko) based on the data captured by the Rosetta space craft and published here by the European Space Agency:
https://imagearchives.esac.esa.int/index.php?/page/navcam_3d_models
Three basic variations are provided:
* One "as-is" STL that you can do with what you will
* One with tree supports generated by Meshmix. Scaling this model may introduce issues with support integrity, but fits on a printer with decent build volume (mine is 235x235 base plate)
* One that has been split in half for very easy printing. Just use CA or epoxy glue to join the two halves.
A fun thing to do is to make/print something to the same scale and put it alongside for comparison. For example, I've printed out a scale picture of the Sydney Harbour Bridge. The comet is approximately 4.1km long, so use that as the basis for calculations.
https://imagearchives.esac.esa.int/index.php?/page/navcam_3d_models
Three basic variations are provided:
* One "as-is" STL that you can do with what you will
* One with tree supports generated by Meshmix. Scaling this model may introduce issues with support integrity, but fits on a printer with decent build volume (mine is 235x235 base plate)
* One that has been split in half for very easy printing. Just use CA or epoxy glue to join the two halves.
A fun thing to do is to make/print something to the same scale and put it alongside for comparison. For example, I've printed out a scale picture of the Sydney Harbour Bridge. The comet is approximately 4.1km long, so use that as the basis for calculations.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!