Comic Book Wall Mount

*Updated model* I must have had a good run with boards because the last few sets have been real twisted. Which meant my comics became prone to falling off the mount. So to solve this problem I kicked the bottom out from ~5/8ths away from the wall to 1.5". Might be overkill but time will tell. Now they lean against the wall and don't care if the boards are bent. Look for "Newcomichanger"

I wanted a wall hanger that used 3m command poster strips(or similar), was quick and easy to print, had a low profile(so not to distract from the comics it would be displaying), and allows me to swap/pull comics with only minimal effort. These are the two designs I came up with.
The regular is meant to be printed on the thin side with the long side on the 'Z'. This way you can pack a large amount into a small area(see picture above). The Lite version I have always printed with the "ears" flat on the bed.

Both of these are made to use unmodified 3M command poster strips. You can get them