Thingiverse
Command strip mount
von mpete53
3
Downloads
1
Likes
0
Makes
Command strips are great but sometimes you want a nail to hang a picture and maybe a little more holding power. This lets you use two strips and a nail to hang things on.
After printing you push the small nail through the part , then using 2 pair of plyers bend the nail over on the back and trim the extra off.
After printing you push the small nail through the part , then using 2 pair of plyers bend the nail over on the back and trim the extra off.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
