Commodore 64 Vic-20 Keyboard Connector

I'm working on a mechanic keyboard for the commodore 64. I need to have a keyboard connector cable. I decided to use a dupont male to male ribbon cable. I didn't want to have to deal with 19 individual wires on each side, so I created this to hold them all together in order, and to mimic the original connector as much as possible.

I needed a connector on both ends, if you are using this to fix and existing keyboard you would only need it on one end and solder the leads to the keyboard motherboard.

What you will need:
Single or double sided dupont male connector cable. Select the length you need. I should have at least 20 connectors.
Male header, at least 20 pins.
Glue, I used JB plastic weld.
Tape, clamps, or whatever to hold the connector together while drying.

How to construct:
Take the male header connector and snap it so one end has 20 connectors.

Remove the 2nd pin from the header connector.

Connect 19 of the dupont connectors to the header pins. The fir