Thingiverse
Commodore 64GS Keyboard Case
von xenomachina
17
Downloads
11
Likes
0
Makes
This is a case for a Commodore 64 keyboard in the style of the Commodre 64GS case. It was inspired by [this thread on Twitter](https://twitter.com/laurence/status/1304610746358095872).
Please note:
1. I have never printed this. While I have tried to make the measurements accurate, it may not actually fit a Commodore 64 keyboard.
2. It is *very* large.
3. There currently is not a hole for cables in the design. There are, however, three different port locations/sizes to choose from. You'll need to drill your own holes in these area, either digitally or after printing. Make sure you select a top and a bottom with the same "port" location. While the port are is completely on the bottom case, the top has a matching overhang.
Please note:
1. I have never printed this. While I have tried to make the measurements accurate, it may not actually fit a Commodore 64 keyboard.
2. It is *very* large.
3. There currently is not a hole for cables in the design. There are, however, three different port locations/sizes to choose from. You'll need to drill your own holes in these area, either digitally or after printing. Make sure you select a top and a bottom with the same "port" location. While the port are is completely on the bottom case, the top has a matching overhang.
xenomachina veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
