Compact 16 peg Shellholder...holder.

A 16 peg holder for shellholders, It matches with my shellplate holders for the hornady progressive press, but can be used on its own. Pegs are reinforced at the base, and overall it's pretty beefy as I didn't want to be printing a new one every year.

This actually worked out well, as there is room for your fingers to grab a shellholder without fighting for it, and it keeps a lot of shell holders in one compact spot. I used a label maker to print which shell holder goes where, and put the labels just below this, as doing raised lettering for each would likely be illegible.

Overall, quite pleased with this one, in conjunction with my shellplate holders, it sets up my current reloading array, and allows for easy expansion. My old setup was just nails hammered into the wall above the bench :)