Thingiverse
Compact Tripod
von BoopidooDesigns
99
Downloads
57
Likes
0
Makes
IMPORTANT, THIS DESIGN IS NOT ALLOWED TO SELL!
Inspired by Kernel770's tripod I re-designed it from scratch. :)
The camPad is printed in flexible TPU and the rest in ecoPLA.
The 1/4-screw is held in place by a small piece of filament glued in place by CA-glue.
Support is recommended when printing camMount.
Using toothed washers with external-tooth is recommended for heavy setups but is otherwise not needed.
As always, if you find it useful a tiny donation goes a long way to show appreciation. :)
Hardware needed:
1 pcs M5x50 hex-head screw
1 pcs M5 nut
2 pcs M5x10 countersunk screws
2 pcs M5 Nyloc nuts
1 pcs 1/4 10mm screw (http://www.amzn.de/dp/B00OOLKD3K)
2 pcs M5 toothed washers (external-tooth)
MY XS tripod version: https://www.thingiverse.com/thing:4488587
Inspired by Kernel770's tripod I re-designed it from scratch. :)
The camPad is printed in flexible TPU and the rest in ecoPLA.
The 1/4-screw is held in place by a small piece of filament glued in place by CA-glue.
Support is recommended when printing camMount.
Using toothed washers with external-tooth is recommended for heavy setups but is otherwise not needed.
As always, if you find it useful a tiny donation goes a long way to show appreciation. :)
Hardware needed:
1 pcs M5x50 hex-head screw
1 pcs M5 nut
2 pcs M5x10 countersunk screws
2 pcs M5 Nyloc nuts
1 pcs 1/4 10mm screw (http://www.amzn.de/dp/B00OOLKD3K)
2 pcs M5 toothed washers (external-tooth)
MY XS tripod version: https://www.thingiverse.com/thing:4488587
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
