Thingiverse
Compad TIE Pilot
von azoroes
39
Downloads
37
Likes
1
Makes
As the CRL for the TIE pilot changed in January 2021 this is a compad fully up to the new standards!
I highly reccomend printing it with a SLA printer as you will hardly get the same finish with an FDM printer.
A small one as the Anycubic Photon / Mono / Elegoo Mars ect. will work just fine and will cost you about 60 grams of Resin.
I highly reccomend printing it with a SLA printer as you will hardly get the same finish with an FDM printer.
A small one as the Anycubic Photon / Mono / Elegoo Mars ect. will work just fine and will cost you about 60 grams of Resin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
