Thingiverse
compasses
by kuba-sl
0
Downloads
0
Likes
0
Makes
Hello!
this is my first thing here on thingiverse, so I hope it is not so terrible. :)
my gf lost her compasses so i designed these simple ones, you just need an old needle from maybe broken compasses or just some wire or something. the hole diameter is 2.15mm because this was the needle I had, you have to either glue it in place or if it is a tight fit then heat the needle and press in.
the thread is in my case on my ender pretty tight, I guess that on a better calibrated printer the thread will have more clearance.
You only need a suitable needle and a pencil. :)
The nice thing about this compass is that if you align it with the pencil, you can write or draw with the pencil and don’t have to remove it and it is still comfortable to use
this is my first thing here on thingiverse, so I hope it is not so terrible. :)
my gf lost her compasses so i designed these simple ones, you just need an old needle from maybe broken compasses or just some wire or something. the hole diameter is 2.15mm because this was the needle I had, you have to either glue it in place or if it is a tight fit then heat the needle and press in.
the thread is in my case on my ender pretty tight, I guess that on a better calibrated printer the thread will have more clearance.
You only need a suitable needle and a pencil. :)
The nice thing about this compass is that if you align it with the pencil, you can write or draw with the pencil and don’t have to remove it and it is still comfortable to use
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
