Thingiverse
Computer Case Front Panel Standoff
door 3Deth
23
Downloads
8
Likes
0
Makes
UPDATE*** 6/14/20
I created some [custom gap fillers](https://www.thingiverse.com/thing:4460184) (wip) to go along with these.
___________________
I noticed my new computer was running really hot when gaming, and I assumed the lack of air intake on the front panel was the culprit. After I removed the front pane entirely, the temps dropped by ~15 degrees.
However, I didn't want to just leave the front panel off the computer, as it completes the look. And I didn't want to modify the panel by drilling or cutting holes.
I designed these standoffs because it's a reversible modification. They put the panel 30mm off the chassis.
My case is an IBUYPOWER Element MR, though, I'm sure these will work on any other case that has a similar front panel with 10mm holes on the chassis and push pin clips on the front panel. And I believe this case is based on an NZXT case.
I did not necessarily need all 8 to hold the front panel, I just used all 8 so I wouldn't see the other unused p
I created some [custom gap fillers](https://www.thingiverse.com/thing:4460184) (wip) to go along with these.
___________________
I noticed my new computer was running really hot when gaming, and I assumed the lack of air intake on the front panel was the culprit. After I removed the front pane entirely, the temps dropped by ~15 degrees.
However, I didn't want to just leave the front panel off the computer, as it completes the look. And I didn't want to modify the panel by drilling or cutting holes.
I designed these standoffs because it's a reversible modification. They put the panel 30mm off the chassis.
My case is an IBUYPOWER Element MR, though, I'm sure these will work on any other case that has a similar front panel with 10mm holes on the chassis and push pin clips on the front panel. And I believe this case is based on an NZXT case.
I did not necessarily need all 8 to hold the front panel, I just used all 8 so I wouldn't see the other unused p
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
