Thingiverse
Control caddy
von AvelP
4
Downloads
4
Likes
0
Makes
This is my fist model, very simple design just for four remote controls,
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/48bE3lI5aK4
Simple remote control caddy, I remake the front for less filament
Printed in PLA, 0.2 mm, 15% lines infill, 215/60 degrees, no support needed
This object was made in Tinkercad. Edit it online https://www.tinkercad.com/things/48bE3lI5aK4
Simple remote control caddy, I remake the front for less filament
Printed in PLA, 0.2 mm, 15% lines infill, 215/60 degrees, no support needed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!