Control Panel Enclosure - Monoprice MakerSelectV2

This is a replacement control box for the stock components of the Monoprice MakerSelectV2. The SD card and USB port are relocated and recessed, and the overall desktop footprint is somewhat smaller. Everything was removed and measured to design this. All panels should print flat (one way or another) without supports. The FrontUpper panel could use a single support for the USB port, but if your machine can handle bridges, it probably wouldn't be very difficult. The hardware from the stock enclosure could be re-used, and I'd recommend running a tap through mounting holes, where appropriate. Perhaps later models will include threads.
I'm printing this throughout the week, so small things may need to be adjusted, however, if you feel it's good enough or you want to make your own modifications go right ahead.

Update: Removed 2.5mm material from all panels to reduce material use and print time, while retaining 5mm thickness in structural interfacing.

Update: Split bottom plate and add