MakerWorld
Electronics
Ver Modelo
Controller and Headset Wall Mount
93
Descargas
33
Likes
34
Makes
This is a universal controller and headset stand. This stand has interchangeable pieces that slide into and out of the stand. You can change it to hold 9 controllers, 6 controllers and 3 headsets, 8 controllers and 1 headset, and so on. There are 3 pieces that are interchangeable: the controller stand, headset stand, and spacers. The spacers are used to separate the other stands from each other to give room for the controllers or headsets. This model is made so that you can thread charging cables through the holes in the model, so the controller can charge while it is resting on the stand There are 2 ways to mount it. I use 4 command hook strips, 2 for the top and 2 for the bottom, and it holds very well for me. There are also screw holes in the model if you prefer that option. I am fully open to any suggestions or improvements.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
