Thingiverse
Controller-Thingi Wall Mount
von OnionsHaveLayers
16
Downloads
9
Likes
0
Makes
A quick, easy, minimal design print for a solid little wall mount.
Originally designed to be a controller mount but can be used for many more applications.
Looks best when whatever you are holding is held above the hooks to hide most of the mount.
Print:
2 x Arms min
1 x Center
2x End Cap - Not necessarily needed to use mount but does act as a stopper for arms.
2 arms minimum to balance on the one screw. I used drywall anchors so i could not get as tight of a fit to the wall as i would of liked. You may be able to get away with one arm depending on what you are holding.
Headphone mount here: https://www.thingiverse.com/thing:5208506
Originally designed to be a controller mount but can be used for many more applications.
Looks best when whatever you are holding is held above the hooks to hide most of the mount.
Print:
2 x Arms min
1 x Center
2x End Cap - Not necessarily needed to use mount but does act as a stopper for arms.
2 arms minimum to balance on the one screw. I used drywall anchors so i could not get as tight of a fit to the wall as i would of liked. You may be able to get away with one arm depending on what you are holding.
Headphone mount here: https://www.thingiverse.com/thing:5208506
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
