Thingiverse
CoolerMaster Q300L Case Riser
por TechProGabe
7
Descargas
5
Likes
0
Makes
This is a leg riser for the CoolerMaster Masterbox Q300L case. You will need 4 of these to fully raise the case off the floor. This was created to prevent the case from sitting on carpet, as the PSU intake is on the bottom.
I was able to print this on an Ender 3 V2. PLA with 10% infill.
I was able to print this on an Ender 3 V2. PLA with 10% infill.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
