Thingiverse
Corner Clock
par SSSR_SH
5
Téléchargements
3
Likes
0
Makes
Corner Clock
Clock dimensions: 180mm.
Quartz clock movement dimensions: 55.8x55.8mm.
Hole size for the logo: 2.2mm
(If you want to replace the logo, the back cylinder can be set to 2mm).
The bracket is installed in the corner using self-tapping screws, either M4 or M5. Only one screw is needed.
(Alternatively, you can use a Plastic Hard Wall Picture Hook with a diameter of 13mm. First, nail it to the wall, then apply adhesive to the holes on the Bracket and stick it to the Hook).
The top of the Bracket can be installed with a pin without using adhesive.
Once the Bracket is installed, simply hang the clock on the Bracket.
No additional support is required.
Recommended fill rate for the clock: 15%-20%.
Recommended fill rate for the Bracket: 30%.
Layer height recommended: 0.2mm.
Clock dimensions: 180mm.
Quartz clock movement dimensions: 55.8x55.8mm.
Hole size for the logo: 2.2mm
(If you want to replace the logo, the back cylinder can be set to 2mm).
The bracket is installed in the corner using self-tapping screws, either M4 or M5. Only one screw is needed.
(Alternatively, you can use a Plastic Hard Wall Picture Hook with a diameter of 13mm. First, nail it to the wall, then apply adhesive to the holes on the Bracket and stick it to the Hook).
The top of the Bracket can be installed with a pin without using adhesive.
Once the Bracket is installed, simply hang the clock on the Bracket.
No additional support is required.
Recommended fill rate for the clock: 15%-20%.
Recommended fill rate for the Bracket: 30%.
Layer height recommended: 0.2mm.
SSSR_SH publie également sur
225 modèles supplémentaires sur 3 autres plateformes
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
