Thingiverse
Corona Strap
von FullPlastic
1
Downloads
2
Likes
0
Makes
Its time to take the fight back to COVID-19 and give it nowhere to hide. Get a fist full of straps and go on the offensive!
Simple idea that came from using electrical heat shrink wrap and also from heat forming the community face mask frame.
Print Copper3D PLA Active antiviral copper nanoparticle strips of 1 layer at 0.3mm.
No top or bottom layers, no infill.
Just lots and lots of walls/shells so you get lots of strength along its length with no gap.
Ensure bed levelling is bang on. I printed on a glass bed with gluestick.
Heat with heatgun, hairdryer, hotwater.
Wrap around handle, Allow to cool. bit of superglue or 3m stickypads on ends. Viola instant self disinfecting surface for very little cost.
Based on this product but much cheaper to produce.
https://www.flexitog.com/Door-Handle-Copper-Overlay
Wont loose antiviral properties when tarnished by sweat within an hour.
http://sciencenetlinks.com/science-news/science-updates/antibacterial-doorknob
Simple idea that came from using electrical heat shrink wrap and also from heat forming the community face mask frame.
Print Copper3D PLA Active antiviral copper nanoparticle strips of 1 layer at 0.3mm.
No top or bottom layers, no infill.
Just lots and lots of walls/shells so you get lots of strength along its length with no gap.
Ensure bed levelling is bang on. I printed on a glass bed with gluestick.
Heat with heatgun, hairdryer, hotwater.
Wrap around handle, Allow to cool. bit of superglue or 3m stickypads on ends. Viola instant self disinfecting surface for very little cost.
Based on this product but much cheaper to produce.
https://www.flexitog.com/Door-Handle-Copper-Overlay
Wont loose antiviral properties when tarnished by sweat within an hour.
http://sciencenetlinks.com/science-news/science-updates/antibacterial-doorknob
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!