Slicer Discord
count it  – 3D-Druckmodell von Thingiverse Thingiverse

count it

von awelshman
0 Downloads
2 Likes
0 Makes
Zum Modell
just a bit of fun

count it before you start
count it while you do it
count it when you finish
it takes 30 seconds to cock it up
30 minutes to put it right

at 100% back is 4mm thick and text is 2mm

i used to work in telecoms and sitting there remaking a cable joint with a few hundred wires needed a bit of concentration

i have done more things , just put awelshman in the search box . or use the link below .if you like this or any of the other stuff please feel free to click the like button

thanks

or

https://www.thingiverse.com/awelshman/designs

Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

awelshman veröffentlicht auch auf

50 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen