CPG Double Display Case

This is the next iteration and release of my design for a display case for models and miniatures, the double size case. This requires a bit more construction than the original single case and as such I have made a (terrible) video of how I built the frame, the same process applies to the cover - this will be available towards the bottom of the description, no voice over as no one would understand my accent. An AMS is not required for this as each build plate is in 1 colour, and construction is relatively straight forward and apart from glue you will need 5mmx2mm magnets to hold the front in place, a clear Perspex sheet 2mm thick and 405x185mm rectangle. The parts go together as per the below diagram: The front of the cover has a lip to hold the Perspex window, the back of the cover has pins for alignment - Note that the split for the back of the cover is 2 pieces and the front 4 pieces and they are offset and each piece will only fit one way - make sure to dry fit and my advice is to u