CR-10 Bed Leveling Test

This is a super quick, super low filament usage Test Print which you can/should use to dial in and adjust the corners for perfect leveling.

My recommended steps:

1) measure the x-axis gantry on both sides (since it is dual-z steppers) to ensure it is perfectly level to the frame. Disable the steppers and adjust as necessary.

2) manually level with a piece of paper on all 4 corners, then auto-level (if you have a CRTouch/BLTouch) and save to eeprom.

3) use the attached .STL file (super quick, super low filament usage) to run a test print and adjust the corners as necessary during it.

4) use the 'Tune | Babystep Z" as necessary when printing the skirt to ensure that you are getting good 'squish'