Cr-10 Filament Sensor Bracket & Tutorial

Overview:
I designed a Bracket to hold a filament run-out sensor i bought off ebay.
When the filament runs out, in this order it will:
1. Pause the print
2. retract filament to stop oozing,
3. move the head away to allow filament change
4. resume back where it initially stopped.

Properties:
- It slips over the Extruder, and also has a cable holder integrated.
- The design allows it so you can use a small amount of PTFE tube to make it easier for the filament to guide into the extruder motor.
- Sensor Light up green when there is filament detected

You Will Need:
-Sensor:
AliExpress: https://goo.gl/FutpoC

-Connectors for Raspberry pi:
http://r.ebay.com/9g8yce

-RaspberryPi running Octoprint


Setup Steps:
1. print out Filament Sensor and Lid
2. Install Sensor inside housing (will be a tight fit)
3. Wire up Sensor to Raspberry Pi. ( follow tutorial if stuck https://youtu.be/j7JfQXTf16U)
4. Install "Filament Sensor Reloaded" plugin on Octopi

Stock Fir