CR-10S/RaspberryPi3 case

I got sick of those 2 loud fans inside the original case and decided to draw new case with single 120x15mm slim fan. I don´t know if the older CR-10 board fits, new with Mega2560 sure does. Inside the case is also a mount for RaspberryPi 3 to run octopi, it sits on high poles to fit those printer cables under RaspberryPi´s usb and network cables.

NECESSARY MODS:
1. With this case you have to mount PSU external, that one you have to figure out by yourself. Search PSU case, I found this one: https://www.thingiverse.com/thing:1745609

2. Also you should install some sort of rubber feet/addhesive tape etc, case is sliding all over my table without some friction between them.

3. On the backside of 12864 board is a speaker, you have to desolder it and solder it to the front side. This makes the display case slimmer.


4.
You need slim 120mm fan to top part, I used Silverstone FW121: http://www.silverstonetek.com/product.php?pid=500
I shortened the cable to 5cm and soldered N