Thingiverse
Creality K1 Lid / Cap Riser
29
Downloads
34
Likes
0
Makes
Want to raise you K1 lid so the filament tube is completely uninhibited? look no further.
This raises the lid 2 inches and bends out slightly to allow even more room for the tube to maneuver.
This raises the lid 2 inches and bends out slightly to allow even more room for the tube to maneuver.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
