Thingiverse
Creality printer basic status display
door ZefDurgen
0
Downloads
0
Likes
0
Makes
Clean LED holes to fit snugly or use hot glue to hold them in place. I used a 10-conductor ribbon cable to connect to the mainboard. I used M4 T-slot bolts and nuts to mount the display on the rail.
Connections are noted for Creality Ender series printers running 24-volt heaters.
Green LEDs are spliced into limit switches no need for resisters.
The red LEDs connect to heater outputs with a 2k ohm resistor on the negative lead.
Use superglue to attach lid to body.
Connections are noted for Creality Ender series printers running 24-volt heaters.
Green LEDs are spliced into limit switches no need for resisters.
The red LEDs connect to heater outputs with a 2k ohm resistor on the negative lead.
Use superglue to attach lid to body.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!