Cross cut stop

The original fence of the miter gauge that comes with the Bosch GTS 10 XC is tiny and almost useless. Therefore I created a larger cross cut fence with a stopper that runs on a T-track and allows to repeat same cuts over and over again.

Apart from the printed parts you need following pieces:
2 screws M8 x 30 mm
2 washers
1 screw M6 x 60 mm
1 nut M6
1 nut M8
Aluminium profile box-shaped as fence for miter gauge, dimensions 50x20 mm, length ca. 500 mm, but can be any length, should be available in hardware store
T-track fitting to alum profile and screws to fix it

Cut out a piece of the alum profile (can be done with the table saw) exactly like the original one so it can be used with the holder of the miter gauge. I use two caps on left and right side but you can leave the alum profile open if you like. I screwed a T-track on top to run the stopper with 2 M8 screws. One of the holes is a snug fit and you may use a thread cutter to make the screw go in easier until it slides