Thingiverse
Cross Vault Table
von JohnA
6
Downloads
9
Likes
0
Makes
Designed in Tinkercad, this is a simple 20mm x 20mm stand with a cross or "groin" vault bottom. Printed vault-side up, should come out nicely.
Cross vault: http://en.wikipedia.org/wiki/Groin_vault
Reminiscent of Wajazn's relay board mount: http://www.thingiverse.com/thing:4106
Tinkercad file: https://tinkercad.com/p/acc0019a5f672961
Cross vault: http://en.wikipedia.org/wiki/Groin_vault
Reminiscent of Wajazn's relay board mount: http://www.thingiverse.com/thing:4106
Tinkercad file: https://tinkercad.com/p/acc0019a5f672961
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
