Thingiverse
Cube robot
par plowna
13
Téléchargements
6
Likes
0
Makes
*Edit: 2018-04-22*: Honestly this should be the last time I change the foot. It's 9.5mm high but I shorted it from the back 0.5mm. Will test out shortly for good fit.
*Edit: 2018-04-18*: Shortened the foot from 10mm to 9mm (from the short edge). I noticed it was just a little too large. I don't think it affects it too much but was just annoying me. I may change it to 9.5mm if the change is too much.
*Edit: 2018-04-03*: Added breakaway supports to the body part so now you can just print it without supports.
*Edit: 2018-03-28*: Quick update after printing. Forearm/shin piece was about 1mm too long, and I put the hole in the wrong place on the foot (centered on the base instead of the top).
If you downloaded it before its worth downloading those two updated STL files.
When I get a chance I'll try my hand and putting some supports into the body part, as its the only one that will need it.
*Edit: 2018-04-18*: Shortened the foot from 10mm to 9mm (from the short edge). I noticed it was just a little too large. I don't think it affects it too much but was just annoying me. I may change it to 9.5mm if the change is too much.
*Edit: 2018-04-03*: Added breakaway supports to the body part so now you can just print it without supports.
*Edit: 2018-03-28*: Quick update after printing. Forearm/shin piece was about 1mm too long, and I put the hole in the wrong place on the foot (centered on the base instead of the top).
If you downloaded it before its worth downloading those two updated STL files.
When I get a chance I'll try my hand and putting some supports into the body part, as its the only one that will need it.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !