Thingiverse
Cup Holder Change Jar
by glyd
4
Downloads
2
Likes
0
Makes
This change jar should fit in most vehicle cup holders.
The lid is designed to print in place with no supports needed.
I have included a combo file, as well as individual files.
The Lid is shaped to allow change to easily drop in.
The lid is about 2mm bigger than it needs to be. I did this to allow room for a couple of small pieces of velcro tape(soft side. see photo) so the lid slides on & off nicely.
The lid is designed to print in place with no supports needed.
I have included a combo file, as well as individual files.
The Lid is shaped to allow change to easily drop in.
The lid is about 2mm bigger than it needs to be. I did this to allow room for a couple of small pieces of velcro tape(soft side. see photo) so the lid slides on & off nicely.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
