Thingiverse
Custom Evo Loop Key
door Whomp
2
Downloads
7
Likes
0
Makes
It's a custom loop key part. I printed this in Resin.
For assembly you will attach the xt90 housing to the enclosure last after the xt-90 female side is fed through a hole on your enclosure- it will push into the housing in reverse. This allows disassembly of everything. Recommend to print the gasket in TPU or similar filament.
SW native file included. It's messy because I iterated a lot, but it's there.
For assembly you will attach the xt90 housing to the enclosure last after the xt-90 female side is fed through a hole on your enclosure- it will push into the housing in reverse. This allows disassembly of everything. Recommend to print the gasket in TPU or similar filament.
SW native file included. It's messy because I iterated a lot, but it's there.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!